|
Using PoolCoating System 10 it's easy to
create a great looking pool in just a few days. Our chief chemist,
Anthony Summers (on the left), has put together this simple step by
step guide to preparing your pool and applying PoolCoating System 10.
Follow these steps and you will be enjoying your new look pool in a matter of
days. Further details can be found on the Information page.
Step 1 - Preparation
Remove any existing liner and make sure that surfaces are clean and free of grease or other contamination.
Pools that are already painted don't need any special preparation (such
as complete removal of the existing paint or coating as with many other
coating systems). Simply make good the surface and then just sand and
clean the existing paint or coating to ensure a sound base for PoolCoating System 10. Surfaces can be slightly dampened but not wet or subject to running
water. Any holes should be made good and all leaks must be stopped using
Antel Water Stop,
Antel Epoxy Putty or
Antel SBR Bonding Agent as appropriate.
Where damp or wet surfaces exist constantly seek technical advice.
Step 2 - Mixing
Ensure that you have a window of fine weather of 4 hours per coat and
that the air temperature is above 10°C. To prepare PoolCoating
System 10 for use, first stir the contents of the larger tin and then add the contents
of the smaller tin and mix vigorously for 4 minutes to ensure thorough
mixing. A drill equipped with a mixing paddle is ideal for this.
Step 3 - Application
Apply using brush, roller or airless spray. Allow to dry (normally 6 - 8 hours
at 20°C). Drying time is dependent on temperature - warmer conditions
shorten the drying time. Apply a second coat of PoolCoating System 10 when the
first coat is touch dry. Finally apply the clear coating of PoolCoating System 10
once the second coat is touch dry.
Step 4 - Refill your pool
Leave PoolCoating System 10 to fully cure for 5 days with an air
temperature of 20°C, a couple of days longer at lower
temperatures, or less at higher temperatures. Then wash your pool with a hosepipe and drain before
refilling.
Now sit back and enjoy
up to 10 years without having to think about re-coating your pool again.
In fact, why not invite your friends and neighbours over and have a
party so they can try out your new look pool?
|
